Differences

This shows you the differences between two versions of the page.

--- analyzer:manual:main_window [2010/04/30 09:27] – sestst
+++ analyzer:manual:main_window [2010/05/04 08:08] – sestst
@@ Line 3: / Line 3: @@
 ====== Main Window ======
-The main window of the Protocol Analyzer presents a list of all received signals in real time. It also presents the status of the scanning. When an audio device is used as input, it presents a VU-meter indicating the signal level.\\
+The main window of the Protocol Analyzer presents a list of all received signals in real time. It also presents the status of the scanning. When an audio device is used as input, it presents a VU-meter indicating the signal level.
+The number of rows presented in the main window for each received signal may vary depending on several factors. Typically you will see two lines, one line with the decoded interpretation of the signal and one line with the raw undecoded version of the signal. If no decoder recognized the signal you will only see the raw signal line or if several decoders could decode the signal you will see one line for each decoder that recognized it.
+Most IR and RF protocols repeats the whole or parts of the message as long as the button on the remote is pressed. The decoders will usually detect these repeated signals and still only present one line, but the value in the //Repeat// column will be increased. The raw signal decoder will usually group these repeats in the same message as well, but sometimes it may not fit in one raw message so you will see several lines of raw messages for one line of decoded message.
+\\
 \\
 {{:analyzer:manual:main_window.png | Analyzer main window}}