Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision
Previous revision
analyzer:manual:main_window [2010/05/04 08:08]
sestst
analyzer:manual:main_window [2018/11/03 02:59] (current)
Line 14: Line 14:
 |1|Tool Bar | |1|Tool Bar |
 |2|Received signal list. Received samples and decoded messages are presented here. The **Time column** is the time the message was received. **Protocol column** specifies the name of the protocol of the received message. **Command and Address columns** refer to the protocol content. **Repeat column** specifies if the number of times the message has been repeated| |2|Received signal list. Received samples and decoded messages are presented here. The **Time column** is the time the message was received. **Protocol column** specifies the name of the protocol of the received message. **Command and Address columns** refer to the protocol content. **Repeat column** specifies if the number of times the message has been repeated|
-|3|A decoded protocol message of the JVC-protocol. Note that the JVC decoder must be active to receive this protocol. Double click this line to see details of the received message in the [[analyzer:​manual:​decoded_window|Decoded Window]].|+|3|A decoded protocol message of the JVC-protocol. Note that the JVC decoder must be active to receive this protocol, see [[analyzer:​manual:​decoders|decoder settings]]. Double click this line to see details of the received message in the [[analyzer:​manual:​decoded_window|Decoded Window]].|
 |4|A raw sample. This actually refers to the same message as above, but is the undecoded signal. Note that the Raw-decoder must be active and view->​Raw must be active to view this. Double click on these line to see the actual signal in the [[analyzer:​manual:​undecoded_window|Raw Signal Window]]| |4|A raw sample. This actually refers to the same message as above, but is the undecoded signal. Note that the Raw-decoder must be active and view->​Raw must be active to view this. Double click on these line to see the actual signal in the [[analyzer:​manual:​undecoded_window|Raw Signal Window]]|
 |5|Source indicator. A microphone when Audio is chosen and a USB-stick when CUL is selected| |5|Source indicator. A microphone when Audio is chosen and a USB-stick when CUL is selected|

Personal Tools