analyzer:manual:settings
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revision | Next revisionBoth sides next revision | ||
| analyzer:manual:settings [2010/05/02 10:31] – sestst | analyzer:manual:settings [2010/05/03 08:04] – sestst | ||
|---|---|---|---|
| Line 31: | Line 31: | ||
| In the example //Flank Swing// was set at 50 and //Flank Length// set to 3, so when the signal changed more than 50 over 3 samples, the flank was detected (see the blue line). Note that the signal changed more than 50 in the following samples as well, but since this was within //Flank Holdoff//, this was not counted. | In the example //Flank Swing// was set at 50 and //Flank Length// set to 3, so when the signal changed more than 50 over 3 samples, the flank was detected (see the blue line). Note that the signal changed more than 50 in the following samples as well, but since this was within //Flank Holdoff//, this was not counted. | ||
| - | The parameters of the flank detector are configured in the Audio Settings Dialog. | + | The parameters of the flank detector are configured in the Audio Settings Dialog. |
| \\ | \\ | ||
| \\ | \\ | ||
analyzer/manual/settings.txt · Last modified: 2018/11/03 02:59 by 127.0.0.1