analyzer:manual:settings
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
analyzer:manual:settings [2010/05/03 08:04] – sestst | analyzer:manual:settings [2018/11/03 02:59] (current) – external edit 127.0.0.1 | ||
---|---|---|---|
Line 41: | Line 41: | ||
|Left Channel|Use the Left audio channel| | |Left Channel|Use the Left audio channel| | ||
|Right Channel|Use the Right audio channel| | |Right Channel|Use the Right audio channel| | ||
- | |Flank Detection|The internal | + | |Flank Detection|Settings for the flank detector (see text above)| |
|Apply ... Filter|If the input signal contains a lot of noise, a digital low pass filter can be applied to the signal before flank detection. This Smooths out the signal. You may have to increase Flank Length when this is used| | |Apply ... Filter|If the input signal contains a lot of noise, a digital low pass filter can be applied to the signal before flank detection. This Smooths out the signal. You may have to increase Flank Length when this is used| | ||
|Flank Swing|The hight of a change needed to count as a flank. Use about half the actual height observed in the [[analyzer: | |Flank Swing|The hight of a change needed to count as a flank. Use about half the actual height observed in the [[analyzer: |
analyzer/manual/settings.txt · Last modified: 2018/11/03 02:59 by 127.0.0.1