Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision
Previous revision
analyzer:manual:settings [2010/05/03 08:04]
sestst
analyzer:manual:settings [2018/11/03 02:59] (current)
Line 41: Line 41:
 |Left Channel|Use the Left audio channel| |Left Channel|Use the Left audio channel|
 |Right Channel|Use the Right audio channel| |Right Channel|Use the Right audio channel|
-|Flank Detection|The internal ​flank detector ​tries to recreate the digital pulses in the analog signal by finding the rising and falling edges (flanks). These are the configuration settings for this module|+|Flank Detection|Settings for the flank detector (see text above)|
 |Apply ... Filter|If the input signal contains a lot of noise, a digital low pass filter can be applied to the signal before flank detection. This Smooths out the signal. You may have to increase Flank Length when this is used| |Apply ... Filter|If the input signal contains a lot of noise, a digital low pass filter can be applied to the signal before flank detection. This Smooths out the signal. You may have to increase Flank Length when this is used|
 |Flank Swing|The hight of a change needed to count as a flank. Use about half the actual height observed in the [[analyzer:​manual:​undecoded_window|raw view]]| |Flank Swing|The hight of a change needed to count as a flank. Use about half the actual height observed in the [[analyzer:​manual:​undecoded_window|raw view]]|

Personal Tools