analyzer:manual:start
Differences
This shows you the differences between two versions of the page.
Next revision | Previous revisionLast revisionBoth sides next revision | ||
analyzer:manual:start [2010/04/26 21:51] – created sestst | analyzer:manual:start [2010/05/02 08:08] – sestst | ||
---|---|---|---|
Line 1: | Line 1: | ||
- | ====== Protocol Analyzer | + | {{: |
- | The protocol Analyzer Tool is intended to help analyzing and decoding slow pulse based protocols such as IR-remote protocols and RF lamp switch protocols. The Analyzer has protocol decoders for a number of standard protocols and can decode the parameters from them. It can also help analyzing the signals of unknown protocols and help in building decoders for new protocols. | + | \\ |
+ | ====== Introduction | ||
+ | The protocol Analyzer Tool is intended to help analyzing and decoding slow pulse based protocols such as IR-remote protocols and RF lamp switch protocols. The Analyzer has protocol decoders for a number of standard protocols and can decode the parameters from them. It can also help analyzing the signals of unknown protocols and help in building decoders for new protocols. | ||
- | {{:analyzer:manual: | + | Currently there are two ways of interfacing the analyzer: |
- | The large section in the middle of the screen is where new detected signals are presented. The signals can be of two sorts: Decoded or Raw. A decoded signal is when an active decoder has managed to decode it and presents the name of the protocol and other basic information about the signal. A raw signal is the undecoded sample with detected pulses. | + | * Audio Input |
+ | * the CUL-USB Stick | ||
+ | The manual consists of the following sections: | ||
+ | |||
+ | * [[analyzer: | ||
+ | * [[analyzer: | ||
+ | * [[analyzer: | ||
+ | * [[analyzer: | ||
+ | * [[analyzer: | ||
+ | * [[analyzer: | ||
+ | \\ | ||
+ | |||
+ | ---- | ||
+ | [[analyzer: |
analyzer/manual/start.txt · Last modified: 2018/11/03 02:59 by 127.0.0.1