analyzer:manual:start
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
analyzer:manual:start [2010/04/27 19:55] – sestst | analyzer:manual:start [2018/11/03 02:59] (current) – external edit 127.0.0.1 | ||
---|---|---|---|
Line 1: | Line 1: | ||
- | ====== Protocol Analyzer | + | {{: |
+ | \\ | ||
+ | ====== Introduction | ||
The protocol Analyzer Tool is intended to help analyzing and decoding slow pulse based protocols such as IR-remote protocols and RF lamp switch protocols. The Analyzer has protocol decoders for a number of standard protocols and can decode the parameters from them. It can also help analyzing the signals of unknown protocols and help in building decoders for new protocols. | The protocol Analyzer Tool is intended to help analyzing and decoding slow pulse based protocols such as IR-remote protocols and RF lamp switch protocols. The Analyzer has protocol decoders for a number of standard protocols and can decode the parameters from them. It can also help analyzing the signals of unknown protocols and help in building decoders for new protocols. | ||
- | ===== Main Window ===== | + | Currently there are two ways of interfacing |
- | Below is the main window | + | |
- | {{ : | + | * Audio Input |
+ | * the CUL-USB Stick | ||
- | |1|Tool Bar | | + | The manual consists |
- | |2|Received signal list. Received samples and decoded messages are presented here. The **Time column** is the time the message was received. **Protocol column** specifies the name of the protocol of the received message. **Command and Address columns** refer to the protocol content. **Repeat column** specifies if the number of times the message has been repeated| | + | |
- | |3|A decoded protocol message of the JVC-protocol. Note that the JVC decoder must be active to receive this protocol. Double click this line to see details of the received message.| | + | |
- | |4|A raw sample. This actually refers to the same message as above, but is the undecoded signal. Note that the Raw-decoder must be active and view-> | + | |
- | |5|Source indicator. A microphone when Audio is chosen and a USB-stick when CUL is selected| | + | |
- | |6|Scanning status. // | + | |
- | |7|Signal level. This is only valid for audio scanning. The bar should reach the green part on the left of the scale when a signal is received| | + | |
- | ===== Tool Bar ===== | + | * [[analyzer: |
- | + | * [[analyzer: | |
- | {{ :analyzer: | + | * [[analyzer: |
- | + | * [[analyzer: | |
- | |1|Load a session of sampled signals| | + | * [[analyzer: |
- | |2|Save the current session of sampled signals| | + | * [[analyzer: |
- | |3|Save the current session of sampled signals under a new name| | + | \\ |
- | |4|Remove the selected row/ | + | |
- | |5|Remove all rows/ | + | |
- | |6|Edit the export | + | |
- | |7|Export | + | |
- | |8|Open the settings window| | + | |
- | |9|Start scanning| | + | |
- | |10|Stop scanning| | + | |
- | |11|Force sampling of current signal. Only valid for audio source| | + | |
- | + | ||
- | ===== Decoders Window ===== | + | |
+ | ---- | ||
+ | [[analyzer: |
analyzer/manual/start.1272390914.txt.gz · Last modified: 2018/11/03 02:57 (external edit)