analyzer:manual:undecoded_window
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
analyzer:manual:undecoded_window [2010/04/28 19:07] – sestst | analyzer:manual:undecoded_window [2010/04/29 20:08] – sestst | ||
---|---|---|---|
Line 1: | Line 1: | ||
+ | {{: | ||
+ | \\ | ||
+ | |||
====== Signal Analysis ====== | ====== Signal Analysis ====== | ||
The Protocol Analyzer can be used to analyze the raw data signals to help understand new protocols and write new decoders. This can also be used to tune the volume of the audio device to optimize reception. | The Protocol Analyzer can be used to analyze the raw data signals to help understand new protocols and write new decoders. This can also be used to tune the volume of the audio device to optimize reception. | ||
Line 42: | Line 45: | ||
You can zoom in and out on this graph in the same way as on the Signal view. | You can zoom in and out on this graph in the same way as on the Signal view. | ||
+ | |||
+ | ===== Reanalyze Signal ===== | ||
+ | In the signal graph you can see if the flank detector has been able to recreate the digital pulse correctly. If not, you have to adjust the flank detector settings in [[analyzer: | ||
+ | {{: | ||
+ | \\ | ||
+ | This will generate a new raw signal entry as if the signal was received again, but using the new flank detector settings. | ||
+ |
analyzer/manual/undecoded_window.txt · Last modified: 2018/11/03 02:59 by 127.0.0.1