analyzer:screenshots
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
analyzer:screenshots [2009/04/08 22:58] – sestst | analyzer:screenshots [2009/04/10 18:18] – sestst | ||
---|---|---|---|
Line 1: | Line 1: | ||
====== Protocol Analyzer ====== | ====== Protocol Analyzer ====== | ||
- | These are screen shots from the [[analyzer: | + | These are screen shots from the [[analyzer: |
===== Main Window ===== | ===== Main Window ===== | ||
Line 12: | Line 12: | ||
This is the same signal but zoomed in on two pulses for detailed analysis: | This is the same signal but zoomed in on two pulses for detailed analysis: | ||
{{: | {{: | ||
+ | |||
+ | ===== Decoded Samples ===== | ||
+ | When a message is decoded by a protocol parser, the real protocol parameters is presented when the line is selected. Here is an example of the Pronto-interpretation of a received message: | ||
+ | |||
+ | {{: | ||
===== Settings ===== | ===== Settings ===== | ||
This is the settings dialog, where the pulse analyzer is configured: | This is the settings dialog, where the pulse analyzer is configured: | ||
+ | |||
{{: | {{: | ||
+ | |||
+ | ===== Decoder configuration ===== | ||
+ | It is possible to configure which protocol decoders should be active. Any number of decoders may be active simultaneously, | ||
+ | |||
+ | {{: | ||
+ | |||
+ |
analyzer/screenshots.txt · Last modified: 2018/11/03 02:59 by 127.0.0.1