cul
Differences
This shows you the differences between two versions of the page.
Next revision | Previous revisionNext revisionBoth sides next revision | ||
cul [2010/07/26 20:56] – created sestst | cul [2010/07/27 20:55] – sestst | ||
---|---|---|---|
Line 1: | Line 1: | ||
- | {{ :cul110.jpg | CUL Radio Transceiver}} | + | {{ :cultotal.jpg | CUL Radio Transceiver}} |
====== NetHomeServer CUL Connection ====== | ====== NetHomeServer CUL Connection ====== | ||
- | CUL 433 is a generic radio transceiver with a CPU and a radio transceiver circuit. | + | [[http:// |
- | NetHomeServer interfaces with the CUL transceiver via the [[cultransceiver | CULTransceiver]]-interface module using specific NetHome firmware on the CUL stick. | + | The CUL hardware supports both reception and transmission, |
+ | |||
+ | ===== Firmware ===== | ||
+ | The CUL 433 device requires firmware (for the on board ATMega32U4 processor). There is a separate NetHome project for firmware for this device and this is available as open source (GPL2). The firmware is a generic puls sender/ | ||
+ | |||
+ | Instructions on how to install the firmware can be found [[installculfirmware|here]]. | ||
+ | |||
+ | |||
+ | NetHomeServer interfaces with the CUL transceiver via the [[cultransceiver | CULTransceiver]]-Item and via the CUL device the Nexa and X10-devices can be controlled. | ||
===== NetHomeServer Modules ===== | ===== NetHomeServer Modules ===== | ||
The CUL-Related objects in the NetHomeServer are: | The CUL-Related objects in the NetHomeServer are: | ||
- | * [[fhz1000pcport]] - Connects with the hardware interface module | + | * [[cultransceiver | CULTransceiver]] - Connects with the hardware interface module |
NetHomeServer-actions. | NetHomeServer-actions. | ||
===== Where to buy ===== | ===== Where to buy ===== | ||
+ | [[http:// | ||
cul.txt · Last modified: 2018/11/03 02:59 by 127.0.0.1