fhz1000pcport
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
fhz1000pcport [2008/03/21 09:39] – sestst | fhz1000pcport [2009/03/21 09:06] – sestst | ||
---|---|---|---|
Line 1: | Line 1: | ||
- | {{port64.png|}} | + | {{port64.png|Interface Module}} |
====== FHZ1000PcPort ====== | ====== FHZ1000PcPort ====== | ||
- | This module is a part of the [[NetHomeServer]]. The FHZ1000PcPort is used to communicate with a hardware device called [[FHZ1000Pc]]. The [[FHZ1000Pc]] gives access to the FS20 radio protocol which is used to control and monitor devices like dimmers, lamps, heating and switches. | + | This module is a part of the [[:start|NetHomeServer]]. The FHZ1000PcPort is used to communicate with a hardware device called [[FHZ1000Pc]]. The [[FHZ1000Pc]] gives access to the FS20 radio protocol which is used to control and monitor devices like dimmers, lamps, heating and switches. |
- | {{fhz1000pc.png|fhz1000pc}} | + | [[FHZ1000Pc |{{fhz1000pc.png|fhz1000pc}}]] |
The [[FHZ1000Pc]] is connected to the server via USB. The FHZ1000PcPort will send any received FS20 radio messages as // | The [[FHZ1000Pc]] is connected to the server via USB. The FHZ1000PcPort will send any received FS20 radio messages as // | ||
Line 19: | Line 19: | ||
===== Events ===== | ===== Events ===== | ||
* Receives **FS20Command(HouseCode, | * Receives **FS20Command(HouseCode, | ||
- | * Emits **FS20Event(HouseCode, | + | * Emits **FS20Event(HouseCode, |
+ | |||
+ | The values in the events are FS20-commands which are the following: | ||
+ | ^Value | ||
+ | |0 | ||
+ | |1-16 |Dim to abs. position | | ||
+ | |17 |On | | ||
+ | |18 |Dim Loop | | ||
+ | |19 |Dim down | | ||
+ | |20 |Dim up | | ||
+ | |21 |Flip On/ | ||
==== See also ==== | ==== See also ==== | ||
- | [[FHZ1000PC]], | + | [[FHZ1000PC]], |
fhz1000pcport.txt · Last modified: 2018/11/03 02:59 by 127.0.0.1