{{:server:hw64.png?nolink|}}
====== FHZ1000PcPort ======
This module is a part of the [[:start|NetHomeServer]]. The FHZ1000PcPort is used to communicate with a hardware device called [[FHZ1000Pc]]. The [[FHZ1000Pc]] gives access to the FS20 radio protocol which is used to control and monitor devices like dimmers, lamps, heating and switches.

 
[[FHZ1000Pc |{{fhz1000pc.png|fhz1000pc}}]]

The [[FHZ1000Pc]] is connected to the server via USB. The FHZ1000PcPort will send any received FS20 radio messages as //FS20Event//-events on the [[NetHomeServer]] event bus. Received //FS20Command//-events will be sent as FS20 radio messages. This module is build using the [[FHZ1000PC]]-class.

===== Attributes =====
  * **State** //[get]// Connected or Disconnected, indicates if the port has found the hardware device.
  * **ReceivedMessages** //[get]// Number of FS20-messages that has been received.
  * **SentMessages** //[get]// Number of FS20-messages that has been received.

===== Actions =====
  * **Reconnect**  If the port did not connect to the device at startup, it is possible to initiate a new attempt via this action.

===== Events =====
  * Receives **FS20Command(HouseCode, DeviceCode, Value)** Will send the received command to the specified address. All parameters are in integer format, not the FS20 1-4-Format.
  * Emits **FS20Event(HouseCode, DeviceCode, Value)** This event is emitted when an FS20 command is received from the [[FHZ1000Pc]].

The values in the events are FS20-commands which are the following:
^Value   ^ Command         ^
|0       |Off                  |
|1-16    |Dim to abs. position |
|17      |On               |
|18      |Dim Loop         |
|19      |Dim down         |
|20      |Dim up           |
|21      |Flip On/Off      |

==== See also ====
[[FHZ1000PC]], [[:start|NetHomeServer]], [[FS20Lamp]], [[FS20RemapButton]], [[fs20]]