User Tools

Site Tools


fs20remapbutton

This is an old revision of the document!


FS20RemapButton

This module is a part of the NetHomeServer. The FS20RemapButton is used to let FS20 buttons control events in the NetHomeServer. You may for example let an FS20 wall switch start your WEB-radio player program. The FS20RemapButton allows you to map all messages that can be sent from a button to specific commands. A command may for example be to call the on-method of a lamp or an external shell file. The syntax of the command is described here. The supported commands are: set, call, event, exec.

Note that depending on configuration ov the FS20-buttons not all commands may be generated. If a single button is configured, then only “Toggle” (short press on the button) and “DimLoop” (press and hold button) are generated. If a two button configuration is used on the FS20-device, then “On”, “Off”, “Dim” and “Bright” can be sent from the buttons.

Attributes

  • HouseCode [get] [set] House code of the FS20Button
  • DeviceCode [get] [set] Device code of the FS20Button
  • FHZ1000PcPort [get] [set] Port to use to recive commands
  • OnCommand [get] [set] Command to execute when “On” is received from the device
  • OffCommand [get] [set] Command to execute when “Off” is received from the device
  • BrightCommand [get] [set] Command to execute when “Bright” is received from the device
  • DimCommand [get] [set] Command to execute when “Dim” is received from the device
  • ToggleCommand [get] [set] Command to execute when “Toggle” is received from the device
  • DimLoopCommand [get] [set] Command to execute when “DimLoop” is received from the device

Actions

  • on Directly trigger the “On” command
  • off Directly trigger the “Off” command
  • bright Directly trigger the “Bright” command
  • dim Directly trigger the “Dim” command
  • toggle Directly trigger the “Toggle” command
  • dimLoop Directly trigger the “DimLoop” command

See also

fs20remapbutton.1237622669.txt.gz · Last modified: 2018/11/03 02:57 (external edit)