homehw
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
homehw [2010/09/30 21:15] – sestst | homehw [2010/10/03 11:28] – sestst | ||
---|---|---|---|
Line 12: | Line 12: | ||
[[homehwrec|{{: | [[homehwrec|{{: | ||
- | To use the microphone as an input, you need to adjust the incoming signal level to the sensitivity | + | With a generic 433.92MHz OOK transmitter connected to the speaker output and the protocol drivers in NetHomeServer, you can control most of the radio controlled remote switches sold in Europe, for example: Nexa system, Chacon or Elro AB600. |
- | {{: | ||
- | |||
- | To use the speaker output for transmission, | ||
- | |||
- | {{: | ||
- | |||
- | |||
- | But to actually send or receive as IR or RF you also need additional interfaces. Fortunatly, building these interfaces is not very hard. You can do it by modifying existing devices or by using special built devices. Here are a few examples of devices I and some other users have built. | ||
- | |||
- | ===== Modifying existing devices ===== | ||
- | |||
- | * [[modupm|Using the UPM thermometer as RF receiver for the 433.92MHz band]] | ||
- | * [[modnexaremote|Using a Nexa remote control as generic 433.92MHz transmitter]] | ||
homehw.txt · Last modified: 2018/11/03 02:59 by 127.0.0.1