Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision
Previous revision
installculfirmware [2010/06/03 08:08]
sestst
installculfirmware [2018/11/03 02:59] (current)
Line 1: Line 1:
 +{{ :cul300.jpg | CUL USB-Stick}}
 +
 +:!: This firmware does not appear to work on CUL V3. There has been changes in the hardware which makes this firmware incompatible
 +
 ====== Installing CUL Firmware ====== ====== Installing CUL Firmware ======
-The CUL-stick has a ATMega32U4 processor on board and it has to be loaded with firmware ​in order to workThere is a special ​CUL-firmware developed ​for NetHomeServer,​ which works together with the encoders and decoders in NetHomeServer and ProtocolAnalyzer.+Before you install the firmware, you should have installed the normal USB-drivers for CULSee the //​[[installculusb|Install ​CUL USB-drivers]]//​-page ​for instructions
  
-The firmware is in a file called NetHomeCUL.hex. In order to install this firmware on the CUL-stick you need the FLIP-tool from [[http://​www.atmel.com|Atmel]]. Flip run on both Windows and Linux.+The CUL-stick has an ATMega32U4 processor on board and it has to be loaded with firmware in order to work. There is a special CUL-firmware developed for NetHomeServer,​ which works together with the encoders and decoders in NetHomeServer and ProtocolAnalyzer. 
 + 
 +The firmware is in a file called NetHomeCUL.hex. In order to install this firmware on the CUL-stick you need the Flip-tool from [[http://​www.atmel.com|Atmel]]. Flip run on both Windows and Linux.
  
  
Line 18: Line 24:
  
 ===== 3. Install USB-drivers ===== ===== 3. Install USB-drivers =====
-When windows asks for the new drivers, select to specify ​a location and browse to the location where you installed Flip, there you will find a folder called usb (for example: C:\Program Files\Atmel\Flip 3.3.4\usb). Select this folder and let Windows install the drivers.+{{:​flipusb.png| Installing USB drivers}} 
 + 
 +When windows asks for the new drivers, select to install from specific ​location and browse to the location where you installed Flip, there you will find a folder called usb (for example: C:\Program Files\Atmel\Flip 3.3.4\usb). Select this folder and let Windows install the drivers.
  
 ===== 4. Start Flip and connect ===== ===== 4. Start Flip and connect =====
Line 25: Line 33:
   * Press the USB-cable symbol and select "​USB"​ in the menu.    * Press the USB-cable symbol and select "​USB"​ in the menu. 
   * Then select "​Open"​ in the requester. ​   * Then select "​Open"​ in the requester. ​
-Now all buttons in the interface should become active+Now all buttons in the interface should become active
 +{{:​flip.png|Flip}}
  
 ===== 5. Backup current firmware =====  ===== 5. Backup current firmware ===== 

Personal Tools