nethomeserver_release200
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revision | Last revisionBoth sides next revision | ||
nethomeserver_release200 [2014/03/01 11:39] – sestst | nethomeserver_release200 [2014/03/01 11:40] – sestst | ||
---|---|---|---|
Line 8: | Line 8: | ||
NetHomeServer is open source! Previously I have given people that have asked for it access to my private repo, but now the entire project is released under GPL. The project is hosted on GitHub under the name [[https:// | NetHomeServer is open source! Previously I have given people that have asked for it access to my private repo, but now the entire project is released under GPL. The project is hosted on GitHub under the name [[https:// | ||
- | {{ :: | + | {{:: |
===== Support for Tellstick ===== | ===== Support for Tellstick ===== | ||
Earlier NetHome has relied on some level of own hardware hacking to provide the sender and receiver interfaces to control RF remote switches. Now NetHome supports the [[http:// | Earlier NetHome has relied on some level of own hardware hacking to provide the sender and receiver interfaces to control RF remote switches. Now NetHome supports the [[http:// | ||
- | {{ :: | + | {{:: |
===== Support for BitBanger ===== | ===== Support for BitBanger ===== | ||
Bitbanger is a driver for RaspberryPi which allows you to connect a very simple RF-Transmitter directly to the GPIO-pins of the RaspberryPi computer board. This makes it possible to build a dirt cheap home control system! It does require some soldering though... | Bitbanger is a driver for RaspberryPi which allows you to connect a very simple RF-Transmitter directly to the GPIO-pins of the RaspberryPi computer board. This makes it possible to build a dirt cheap home control system! It does require some soldering though... | ||
nethomeserver_release200.txt · Last modified: 2018/11/03 02:59 by 127.0.0.1