x10housescene
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
x10housescene [2008/10/05 11:57] – sestst | x10housescene [2009/03/21 08:53] – sestst | ||
---|---|---|---|
Line 1: | Line 1: | ||
{{port64.png|}} | {{port64.png|}} | ||
====== X10HouseScene ====== | ====== X10HouseScene ====== | ||
- | This module is a part of the [[NetHomeServer]]. The X10HouseScene is used to control X10-devices via the [[X10Port]] module. The X10 protocol allows for some manipulation of all units with the same a HouseCode with single commands. For example swith off all units with HouseCode ' | + | This module is a part of the [[:start|NetHomeServer]]. The X10HouseScene is used to control X10-devices via the [[X10Port]] module. The X10 protocol allows for some manipulation of all units with the same a HouseCode with single commands. For example swith off all units with HouseCode ' |
===== Attributes ===== | ===== Attributes ===== | ||
Line 9: | Line 9: | ||
* **AllLampsOn** | * **AllLampsOn** | ||
* **allLampsOff** Turn off all devices regarded as lamps | * **allLampsOff** Turn off all devices regarded as lamps | ||
- | * **allUnitsOff** Turn on all devices | + | * **allUnitsOff** Turn off all devices |
* **presetDim1** Set all devices to preset state 1. This command is usually not implemented in the devices and is now considered depricated. | * **presetDim1** Set all devices to preset state 1. This command is usually not implemented in the devices and is now considered depricated. | ||
* **presetDim2** Set all devices to preset state 2. This command is usually not implemented in the devices and is now considered depricated. | * **presetDim2** Set all devices to preset state 2. This command is usually not implemented in the devices and is now considered depricated. |
x10housescene.txt · Last modified: 2018/11/03 02:59 by 127.0.0.1