Differences

This shows you the differences between two versions of the page.

--- x10lamp [2008/03/26 22:32] – created sestst
+++ x10lamp [2009/08/17 22:10] – sestst
@@ Line 1: / Line 1: @@
-{{port64.png|}}
+{{:lightbulb_on64.png| Lamp}}
 ====== X10Lamp ======
-This module is a part of the [[NetHomeServer]]. The X10Lamp is not yet documented.
+This module is a part of the [[:start|NetHomeServer]]. The X10Lamp is an interface to X10 switch and dimmer devices. Via this object lamps or other devices connected to may be controlled.
 ===== Attributes =====
-  * **State** //[get]//
+  * **State** //[get]// Current state of the device: "On" or "Off"
-  * **HouseCode** //[get] [set]//
+  * **HouseCode** //[get] [set]// House code of corresponding device
-  * **DeviceCode** //[get] [set]//
+  * **DeviceCode** //[get] [set]// House code of corresponding device
-  * **X10Port** //[get] [set]//
+  * **X10Port** //[get] [set]// X10Port to use to send the X10 commands. This may be left blank, and in that case the message is sent by all X10-ports attached to the server.
 ===== Actions =====
-  * **on**
+  * **on** Switch on the device to last dim state
-  * **off**
+  * **off**  Switch off the device
-  * **bright**
+  * **bright**  Increase brightness one step. If the device was off it is turned on.
-  * **dim**
+  * **dim**  Decrease brightness one step. If the device was off it is turned on.
-  * **toggle**
+  * **toggle**  Toggle current On/Off state. Note, the X10 devices does not support this operation, so it is implemented in the X10Lamp module. If the current On/Off-state of the actual device differs from the state in the corresponding X10Lamp, this will not work properly at first try.
-  * **dimLoop**
 ==== See also ====
-[[NetHomeServer]]
+[[:start|NetHomeServer]], [[X10]], [[X10Port]]