Differences

This shows you the differences between two versions of the page.

--- x10lamp [2008/10/03 22:06] – sestst
+++ x10lamp [2018/11/03 02:59] (current) – external edit 127.0.0.1
@@ Line 1: / Line 1: @@
-{{port64.png|}}
+{{:lightbulb_on64.png| Lamp}}
 ====== X10Lamp ======
-This module is a part of the [[NetHomeServer]]. The X10Lamp is an interface to X10 switch and dimmer devices. Via this object lamps or other devices connected to may be controlled.
+This module is a part of the [[:start|NetHomeServer]]. The X10Lamp is an interface to X10 switch and dimmer devices. Via this object lamps or other devices connected to may be controlled.
 ===== Attributes =====
   * **State** //[get]// Current state of the device: "On" or "Off"
   * **HouseCode** //[get] [set]// House code of corresponding device
   * **DeviceCode** //[get] [set]// House code of corresponding device
-  * **X10Port** //[get] [set]// X10Port to use to send the X10 commands
+  * **X10Port** //[get] [set]// X10Port to use to send the X10 commands. This may be left blank, and in that case the message is sent by all X10-ports attached to the server.
 ===== Actions =====
   * **on** Switch on the device to last dim state
@@ Line 12: / Line 13: @@
   * **bright**  Increase brightness one step. If the device was off it is turned on.
   * **dim**  Decrease brightness one step. If the device was off it is turned on.
-  * **toggle**  Toggle current On/Off state
+  * **toggle**  Toggle current On/Off state. Note, the X10 devices does not support this operation, so it is implemented in the X10Lamp module. If the current On/Off-state of the actual device differs from the state in the corresponding X10Lamp, this will not work properly at first try.
-  * **dimLoop**  Change brightness one step. Loops brightness up and down. If the device was off it is turned on.
 ==== See also ====
-[[NetHomeServer]]
+[[:start|NetHomeServer]], [[X10]], [[X10Port]]