Nethome

This page is read only. You can view the source, but not change it. Ask your administrator if you think this is wrong.
====== Protocol Analyzer ======
These are screen shots from the [[analyzer:start|Protocol Analyzer]]-tool which is designed for analyzing and decoding slow pulse based protocols.

===== Main Window =====
This is the main window with two JVC-protocol messages received, and the corresponding raw samples.
{{:analyzer:pa_main.png|Analyzer main window}}

===== Raw Samples =====
This is the raw sample screen from the listing above with the flank detectors interpretation and pulse length statistics.
{{:analyzer:pa_raw.png|Raw sample screen}}

This is the same signal but zoomed in on two pulses for detailed analysis:
{{:analyzer:pa_rawzoom.png|Zoom on raw sample screen}}

===== Decoded Samples =====
When a message is decoded by a protocol parser, the real protocol parameters is presented when the line is selected. Here is an example of the Pronto-interpretation of a received message:

{{:analyzer:pa_pronto.png| Pronto version of a Nexa message}}

===== Settings =====
This is the settings dialog, where the pulse analyzer is configured:

{{:analyzer:pa_settings.png| Settings Dialog}}

===== Decoder configuration =====
It is possible to configure which protocol decoders should be active. Any number of decoders may be active simultaneously, but since some of them overlap, it is often useful to exclude some of the decoders.

{{:analyzer:pa_decoders.png| Decoder configuration dialog}}