analyzer:manual:main_window
Differences
This shows you the differences between two versions of the page.
Next revision | Previous revision | ||
analyzer:manual:main_window [2010/04/29 19:57] – created sestst | analyzer:manual:main_window [2018/11/03 02:59] (current) – external edit 127.0.0.1 | ||
---|---|---|---|
Line 3: | Line 3: | ||
====== Main Window ====== | ====== Main Window ====== | ||
- | Below is the main window of the Protocol Analyzer: | + | The main window of the Protocol Analyzer |
- | {{: | + | The number of rows presented in the main window |
+ | |||
+ | Most IR and RF protocols repeats the whole or parts of the message as long as the button on the remote is pressed. The decoders will usually detect these repeated signals and still only present one line, but the value in the //Repeat// column will be increased. The raw signal decoder will usually group these repeats in the same message as well, but sometimes it may not fit in one raw message so you will see several lines of raw messages for one line of decoded message. | ||
\\ | \\ | ||
\\ | \\ | ||
+ | {{: | ||
^Nr^Explanation^ | ^Nr^Explanation^ | ||
|1|Tool Bar | | |1|Tool Bar | | ||
|2|Received signal list. Received samples and decoded messages are presented here. The **Time column** is the time the message was received. **Protocol column** specifies the name of the protocol of the received message. **Command and Address columns** refer to the protocol content. **Repeat column** specifies if the number of times the message has been repeated| | |2|Received signal list. Received samples and decoded messages are presented here. The **Time column** is the time the message was received. **Protocol column** specifies the name of the protocol of the received message. **Command and Address columns** refer to the protocol content. **Repeat column** specifies if the number of times the message has been repeated| | ||
- | |3|A decoded protocol message of the JVC-protocol. Note that the JVC decoder must be active to receive this protocol. Double click this line to see details of the received message in the [[analyzer: | + | |3|A decoded protocol message of the JVC-protocol. Note that the JVC decoder must be active to receive this protocol, see [[analyzer: |
|4|A raw sample. This actually refers to the same message as above, but is the undecoded signal. Note that the Raw-decoder must be active and view-> | |4|A raw sample. This actually refers to the same message as above, but is the undecoded signal. Note that the Raw-decoder must be active and view-> | ||
|5|Source indicator. A microphone when Audio is chosen and a USB-stick when CUL is selected| | |5|Source indicator. A microphone when Audio is chosen and a USB-stick when CUL is selected| | ||
Line 18: | Line 21: | ||
\\ | \\ | ||
\\ | \\ | ||
+ | \\ | ||
+ | \\ | ||
+ | \\ | ||
+ | \\ | ||
+ | \\ | ||
+ | |||
===== Tool Bar ===== | ===== Tool Bar ===== | ||
Line 37: | Line 46: | ||
|10|Stop scanning| | |10|Stop scanning| | ||
|11|Force sampling of current signal. Only valid for audio source| | |11|Force sampling of current signal. Only valid for audio source| | ||
+ | |||
+ | \\ | ||
+ | |||
+ | ---- | ||
+ | [[analyzer: | ||
+ | [[analyzer: | ||
analyzer/manual/main_window.txt · Last modified: 2018/11/03 02:59 by 127.0.0.1