analyzer:manual:start
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
analyzer:manual:start [2010/04/29 20:03] – sestst | analyzer:manual:start [2018/11/03 02:59] (current) – external edit 127.0.0.1 | ||
---|---|---|---|
Line 3: | Line 3: | ||
====== Introduction ====== | ====== Introduction ====== | ||
The protocol Analyzer Tool is intended to help analyzing and decoding slow pulse based protocols such as IR-remote protocols and RF lamp switch protocols. The Analyzer has protocol decoders for a number of standard protocols and can decode the parameters from them. It can also help analyzing the signals of unknown protocols and help in building decoders for new protocols. | The protocol Analyzer Tool is intended to help analyzing and decoding slow pulse based protocols such as IR-remote protocols and RF lamp switch protocols. The Analyzer has protocol decoders for a number of standard protocols and can decode the parameters from them. It can also help analyzing the signals of unknown protocols and help in building decoders for new protocols. | ||
+ | |||
+ | Currently there are two ways of interfacing the analyzer: | ||
+ | |||
+ | * Audio Input | ||
+ | * the CUL-USB Stick | ||
The manual consists of the following sections: | The manual consists of the following sections: | ||
Line 11: | Line 16: | ||
* [[analyzer: | * [[analyzer: | ||
* [[analyzer: | * [[analyzer: | ||
+ | * [[analyzer: | ||
+ | \\ | ||
+ | ---- | ||
+ | [[analyzer: |
analyzer/manual/start.1272564184.txt.gz · Last modified: 2018/11/03 02:57 (external edit)