analyzer:screenshots
Differences
This shows you the differences between two versions of the page.
Next revision | Previous revisionLast revisionBoth sides next revision | ||
analyzer:screenshots [2009/04/04 16:11] – created sestst | analyzer:screenshots [2010/05/27 21:02] – sestst | ||
---|---|---|---|
Line 1: | Line 1: | ||
====== Protocol Analyzer ====== | ====== Protocol Analyzer ====== | ||
- | These are screen shots from the [[analyzer: | + | These are screen shots from the [[analyzer: |
===== Main Window ===== | ===== Main Window ===== | ||
- | This is the main window with two JVC-protocol messages received, and the corresponding raw samples. | + | This is the main window with a JVC-protocol messages received, and the corresponding raw samples. |
- | {{: | + | |
+ | {{: | ||
===== Raw Samples ===== | ===== Raw Samples ===== | ||
This is the raw sample screen from the listing above with the flank detectors interpretation and pulse length statistics. | This is the raw sample screen from the listing above with the flank detectors interpretation and pulse length statistics. | ||
- | {{: | + | {{: |
- | This is the same signal but zoomed in on two pulses for detailed analysis: | + | ===== Decoded Samples ===== |
- | {{: | + | When a message |
+ | |||
+ | {{: | ||
===== Settings ===== | ===== Settings ===== | ||
+ | This is the settings dialog, where the pulse analyzer is configured: | ||
+ | |||
+ | {{: | ||
+ | |||
+ | ===== Decoder configuration ===== | ||
+ | It is possible to configure which protocol decoders should be active. Any number of decoders may be active simultaneously, | ||
+ | |||
+ | {{: | ||
+ | |||
analyzer/screenshots.txt · Last modified: 2018/11/03 02:59 by 127.0.0.1