installculfirmware
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
installculfirmware [2010/06/02 20:46] – sestst | installculfirmware [2010/06/04 07:56] – sestst | ||
---|---|---|---|
Line 1: | Line 1: | ||
====== Installing CUL Firmware ====== | ====== Installing CUL Firmware ====== | ||
- | The CUL-stick has a ATMega32U4 processor on board and it has to be loaded with firmware | + | Before you install the firmware, you should have installed the normal USB-drivers for CUL. See the // |
- | The firmware is in a file called NetHomeCUL.hex. In order to install this firmware on the CUL-stick you need the FLIP-tool from [[http:// | + | The CUL-stick has an ATMega32U4 processor on board and it has to be loaded with firmware in order to work. There is a special CUL-firmware developed for NetHomeServer, |
+ | |||
+ | The firmware is in a file called NetHomeCUL.hex. In order to install this firmware on the CUL-stick you need the Flip-tool from [[http:// | ||
Line 15: | Line 17: | ||
{{: | {{: | ||
- | Now you have to press this button and keep it pressed WHILE you plug in the CUL-Stick. This is easier if you have the CUL-stick connected to an USB extension cable. | + | Now you have to press this button and keep it pressed WHILE you plug in the CUL-Stick. This is easier if you have the CUL-stick connected to an USB extension cable. |
+ | |||
+ | ===== 3. Install USB-drivers ===== | ||
+ | {{: | ||
+ | |||
+ | When windows asks for the new drivers, select to install from a specific location and browse to the location where you installed Flip, there you will find a folder called usb (for example: C:\Program Files\Atmel\Flip 3.3.4\usb). Select this folder and let Windows install the drivers. | ||
+ | |||
+ | ===== 4. Start Flip and connect ===== | ||
+ | Start the Flip program. | ||
+ | * Press the "// | ||
+ | * Press the USB-cable symbol and select " | ||
+ | * Then select " | ||
+ | Now all buttons in the interface should become active: | ||
+ | {{: | ||
- | ===== Install USB-drivers | + | ===== 5. Backup current firmware |
- | When windows asks for the new drivers, select to specify | + | It might be a good idea to start by backing up the current firmware. |
+ | * Press the "// | ||
+ | * Select | ||
+ | * Select the menu // | ||
+ | * Select the menu // | ||
+ | ===== 6. Write new firmware ===== | ||
+ | Now its finally time to write the new firmware | ||
+ | * Select the menu // | ||
+ | * Browse to the NetHomeCUL.hex file and load it | ||
+ | * Press the "// | ||
+ | * Press the "// | ||
+ | * Press the "// | ||
+ | The new firmware is now installed! | ||
+ | ===== 7. Run new firmware ===== | ||
+ | To run the new firmware, unplug the CUL-Stick and then plug it in again (without pressing the little button). The Led should now start blinking! | ||
installculfirmware.txt · Last modified: 2018/11/03 02:59 by 127.0.0.1