User Tools

Site Tools


installculfirmware

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revisionPrevious revision
Next revision
Previous revision
installculfirmware [2010/06/03 22:18] seststinstallculfirmware [2018/11/03 02:59] (current) – external edit 127.0.0.1
Line 1: Line 1:
 +{{ :cul300.jpg | CUL USB-Stick}}
 +
 +:!: This firmware does not appear to work on CUL V3. There has been changes in the hardware which makes this firmware incompatible
 +
 ====== Installing CUL Firmware ====== ====== Installing CUL Firmware ======
 Before you install the firmware, you should have installed the normal USB-drivers for CUL. See the //[[installculusb|Install CUL USB-drivers]]//-page for instructions.  Before you install the firmware, you should have installed the normal USB-drivers for CUL. See the //[[installculusb|Install CUL USB-drivers]]//-page for instructions. 
  
-The CUL-stick has ATMega32U4 processor on board and it has to be loaded with firmware in order to work. There is a special CUL-firmware developed for NetHomeServer, which works together with the encoders and decoders in NetHomeServer and ProtocolAnalyzer.+The CUL-stick has an ATMega32U4 processor on board and it has to be loaded with firmware in order to work. There is a special CUL-firmware developed for NetHomeServer, which works together with the encoders and decoders in NetHomeServer and ProtocolAnalyzer.
  
-The firmware is in a file called NetHomeCUL.hex. In order to install this firmware on the CUL-stick you need the FLIP-tool from [[http://www.atmel.com|Atmel]]. Flip run on both Windows and Linux.+The firmware is in a file called NetHomeCUL.hex. In order to install this firmware on the CUL-stick you need the Flip-tool from [[http://www.atmel.com|Atmel]]. Flip run on both Windows and Linux.
  
  
installculfirmware.1275596338.txt.gz · Last modified: 2018/11/03 02:57 (external edit)