LampGroup
This module is a part of the NetHomeServer. The LampGroup is used to control groups of lamps. You specify which lamps belong to the group and can then switch all on or off with one command. The LampGroup also remembers the state of all lamps when you last used it to switch them off, and you can recall this state by using the recall action.
Attributes
- State [get] State of the group on/off
- Lamps [get] [set] List of lamps in the group
- Delay [get] [set] delay (in milliseconds) between turning each lamp in the group on or off.
Actions
- on
- off
- toggle
- recall
- dim1 Dim all lamps to preset level 1. If the lamp does not support dim it is turned on.
- dim2 Dim all lamps to preset level 2. If the lamp does not support dim it is turned on.
- dim3 Dim all lamps to preset level 3. If the lamp does not support dim it is turned on.
- dim4 Dim all lamps to preset level 4. If the lamp does not support dim it is turned on.