NexaLCAdvancedRemapButton

This module is a part of the NetHomeServer. The NexaLCAdvancedRemapButton is used to control actions in NetHomeServer with a Nexa remote control (or wall switch). Position has an on-button and an off-button.

you can map separate actions for when you press the button, release the button and release after having pressed for a longer time. Action on release is useful when you want the action to send commands using the same radio band as the button uses.

• State [get] If the item is activated or not
• Address [get] [set] Address of the remote
• Button [get] [set] button number
• PressOn [get] [set] Action when on button is pressed
• ReleaseOn [get] [set] Action when on button is released
• ReleaseLongOn [get] [set] Action when on button is released after being pressed a longer time
• PressOff [get] [set] Action when off button is pressed
• ReleaseOff [get] [set] Action when on button is released
• ReleaseLongOff [get] [set] Action when off button is released after being pressed a longer time
• HoldOffTime [get] [set] How long time shall pass (in ms) without a signal to regard the button as released
• LongPressTime [get] [set] How long time you need to press the button (in ms) to regard it as a long time

• on
• off
• enable
• disable

NetHomeServer