Differences

This shows you the differences between two versions of the page.

--- prontolamp [2010/07/28 22:17] – created sestst
+++ prontolamp [2010/07/28 22:36] – sestst
@@ Line 1: / Line 1: @@
-{{port64.png|}}
+{{:lightbulb_on64.png|Lamp Item}}
 ====== ProntoLamp ======
-This module is a part of the [[NetHomeServer]]. The ProntoLamp is not yet documented.
+This module is a part of the [[start|NetHomeServer]]. The ProntoLamp is when you have a device (for example a radio controlled switch) which is not yet supported by NetHomeServer, but you have the Pronto-codes for the radio signals. Both the [[audioprotocoltransmitter|AudioProtocolTransmitter]] and the [[cultransceiver|CULTransceiver]] supports sending Pronto codes, so this way you may control new devices.
+Pronto-codes may be found on the net, but may also be found using the [[analyzer:start|Protocol Analyzer]] if you have a compatible radio/IR receiver.
+the [[cultransceiver|CULTransceiver]] you can also send the messages as IR if you have a [[powermid|PowerMid]]
 ===== Attributes =====
-  * **State** //[get]//
+  * **State** //[get]// Current state of the device (On/Off)
-  * **OnCode** //[get] [set]//
+  * **OnCode** //[get] [set]// The Pronto code to turn the device on
-  * **OffCode** //[get] [set]//
+  * **OffCode** //[get] [set]// The Pronto code to turn the device off
-  * **Repeat** //[get] [set]//
+  * **Repeat** //[get] [set]// Number of repeats of the code to send
-  * **UseModulation** //[get] [set]//
+  * **UseModulation** //[get] [set]// The Pronto code contains information about the modulation frequency. If the message shall be sent as IR, this should be set to true.
 ===== Actions =====
-  * **on**
+  * **on**  Turn the device on, which means sending the //OnCode//
-  * **off**
+  * **off**  Turn the device off, which means sending the //OffCode//
-  * **toggle**
+  * **toggle**  Toggle current state and send //OnCode// or //OffCode//
 ==== See also ====
-[[NetHomeServer]]
+[[start|NetHomeServer]]