User Tools

Site Tools


prontolamp

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Next revision
Previous revision
prontolamp [2010/07/28 22:17] – created seststprontolamp [2018/11/03 02:59] (current) – external edit 127.0.0.1
Line 1: Line 1:
-{{port64.png|}}+{{:lightbulb_on64.png|Lamp Item}}
 ====== ProntoLamp ====== ====== ProntoLamp ======
-This module is a part of the [[NetHomeServer]]. The ProntoLamp is not yet documented.+This module is a part of the [[start|NetHomeServer]]. The ProntoLamp is when you have a device (for example a radio controlled switch) which is not yet supported by NetHomeServer, but you have the Pronto-codes for the radio signalsBoth the [[audioprotocoltransmitter|AudioProtocolTransmitter]] and the [[cultransceiver|CULTransceiver]] supports sending Pronto codes, so this way you may control new devices. 
 + 
 +Pronto-codes may be found on the net, but may also be found using the [[analyzer:start|Protocol Analyzer]] if you have a compatible radio/IR receiver. 
 + 
 +the [[cultransceiver|CULTransceiver]] you can also send the messages as IR if you have a [[powermid|PowerMid]] 
 ===== Attributes ===== ===== Attributes =====
-  * **State** //[get]//  +  * **State** //[get]// Current state of the device (On/Off) 
-  * **OnCode** //[get] [set]//  +  * **OnCode** //[get] [set]// The Pronto code to turn the device on 
-  * **OffCode** //[get] [set]//  +  * **OffCode** //[get] [set]// The Pronto code to turn the device off  
-  * **Repeat** //[get] [set]//  +  * **Repeat** //[get] [set]// Number of repeats of the code to send 
-  * **UseModulation** //[get] [set]// +  * **UseModulation** //[get] [set]// The Pronto code contains information about the modulation frequency. If the message shall be sent as IR, this should be set to true.
 ===== Actions ===== ===== Actions =====
-  * **on**   +  * **on**  Turn the device on, which means sending the //OnCode// 
-  * **off**   +  * **off**  Turn the device off, which means sending the //OffCode//   
-  * **toggle**  +  * **toggle**  Toggle current state and send //OnCode// or //OffCode//
 ==== See also ==== ==== See also ====
-[[NetHomeServer]]+[[start|NetHomeServer]]
  
prontolamp.1280348240.txt.gz · Last modified: 2018/11/03 02:57 (external edit)