upmprotocol
Differences
This shows you the differences between two versions of the page.
Next revisionBoth sides next revision | |||
upmprotocol [2010/08/31 20:55] – created sestst | upmprotocol [2010/08/31 21:00] – sestst | ||
---|---|---|---|
Line 1: | Line 1: | ||
====== UPM Protocol ====== | ====== UPM Protocol ====== | ||
- | The RF-Protocol used by the UPM-Devices uses OOK-modulation of the 433.92MHz carrier signal. The digital signal is encoded using an Biphase Differential Manchester encoding to code the actual bits. One message consists of 28 bits of data and is always repeated three times for redundancy. The temperature sensors sends a burst of three messages once every minute, and just uses "blind luck" not to send at the same time as another sensor if you have multiple sensors. In reality the sensor' | + | The RF-Protocol used by the UPM-Devices uses OOK-modulation of the 433.92MHz carrier signal. The digital signal is encoded using an Biphase Differential Manchester encoding to code the actual bits. One message consists of 28 bits of data and is always repeated three times for redundancy. The temperature sensors sends a burst of three messages once every minute, and just uses "blind luck" not to send at the same time as another sensor if you have multiple sensors. In reality the sensor' |
The UPM receivers are quite smart when it comes to saving energy. When you start them they will switch on the receiver and scan for sensors for a couple of minutes. Once it has located the sensors (when they transmit), it will turn off the receiver and just turn it on when it expects the next transmission from one of the sensors and as soon as it has decoded a complete message it turns off the receiver again (usually after the first of the three repeats in a burst). | The UPM receivers are quite smart when it comes to saving energy. When you start them they will switch on the receiver and scan for sensors for a couple of minutes. Once it has located the sensors (when they transmit), it will turn off the receiver and just turn it on when it expects the next transmission from one of the sensors and as soon as it has decoded a complete message it turns off the receiver again (usually after the first of the three repeats in a burst). |
upmprotocol.txt · Last modified: 2018/11/03 02:59 by 127.0.0.1