{{:lightbulb_on64.png| Lamp}}
====== X10Lamp ======
This module is a part of the [[:start|NetHomeServer]]. The X10Lamp is an interface to X10 switch and dimmer devices. Via this object lamps or other devices connected to may be controlled.
===== Attributes =====
  * **State** //[get]// Current state of the device: "On" or "Off"
  * **HouseCode** //[get] [set]// House code of corresponding device
  * **DeviceCode** //[get] [set]// House code of corresponding device 
  * **X10Port** //[get] [set]// X10Port to use to send the X10 commands. This may be left blank, and in that case the message is sent by all X10-ports attached to the server.

===== Actions =====
  * **on** Switch on the device to last dim state 
  * **off**  Switch off the device
  * **bright**  Increase brightness one step. If the device was off it is turned on.
  * **dim**  Decrease brightness one step. If the device was off it is turned on.
  * **toggle**  Toggle current On/Off state. Note, the X10 devices does not support this operation, so it is implemented in the X10Lamp module. If the current On/Off-state of the actual device differs from the state in the corresponding X10Lamp, this will not work properly at first try.
==== See also ====
[[:start|NetHomeServer]], [[X10]], [[X10Port]]