User Tools

Site Tools


nexalcadvancedremapbutton

NexaLCAdvancedRemapButton

This module is a part of the NetHomeServer. The NexaLCAdvancedRemapButton is used to control actions in NetHomeServer with a Nexa remote control (or wall switch). Position has an on-button and an off-button.

you can map separate actions for when you press the button, release the button and release after having pressed for a longer time. Action on release is useful when you want the action to send commands using the same radio band as the button uses.

Attributes

  • State [get] If the item is activated or not
  • Address [get] [set] Address of the remote
  • Button [get] [set] button number
  • PressOn [get] [set] Action when on button is pressed
  • ReleaseOn [get] [set] Action when on button is released
  • ReleaseLongOn [get] [set] Action when on button is released after being pressed a longer time
  • PressOff [get] [set] Action when off button is pressed
  • ReleaseOff [get] [set] Action when on button is released
  • ReleaseLongOff [get] [set] Action when off button is released after being pressed a longer time
  • HoldOffTime [get] [set] How long time shall pass (in ms) without a signal to regard the button as released
  • LongPressTime [get] [set] How long time you need to press the button (in ms) to regard it as a long time

Actions

  • on
  • off
  • enable
  • disable

See also

nexalcadvancedremapbutton.txt · Last modified: 2018/11/03 02:59 by 127.0.0.1