User Tools

Site Tools


x10lamp

 Lamp

X10Lamp

This module is a part of the NetHomeServer. The X10Lamp is an interface to X10 switch and dimmer devices. Via this object lamps or other devices connected to may be controlled.

Attributes

  • State [get] Current state of the device: “On” or “Off”
  • HouseCode [get] [set] House code of corresponding device
  • DeviceCode [get] [set] House code of corresponding device
  • X10Port [get] [set] X10Port to use to send the X10 commands. This may be left blank, and in that case the message is sent by all X10-ports attached to the server.

Actions

  • on Switch on the device to last dim state
  • off Switch off the device
  • bright Increase brightness one step. If the device was off it is turned on.
  • dim Decrease brightness one step. If the device was off it is turned on.
  • toggle Toggle current On/Off state. Note, the X10 devices does not support this operation, so it is implemented in the X10Lamp module. If the current On/Off-state of the actual device differs from the state in the corresponding X10Lamp, this will not work properly at first try.

See also

x10lamp.txt · Last modified: 2018/11/03 02:59 by 127.0.0.1