cul
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
cul [2010/07/27 20:05] – sestst | cul [2010/07/27 20:46] – sestst | ||
---|---|---|---|
Line 1: | Line 1: | ||
- | {{ :cul110.jpg | CUL Radio Transceiver}} | + | {{ :cultotal.jpg | CUL Radio Transceiver}} |
====== NetHomeServer CUL Connection ====== | ====== NetHomeServer CUL Connection ====== | ||
- | [[http:// | + | [[http:// |
+ | |||
+ | The CUL hardware supports both reception and transmission, | ||
+ | |||
+ | ===== Firmware ===== | ||
+ | The CUL 433 device requires firmware (for the on board ATMega32U4 processor). There is a separate NetHome project for firmware for this device and this is available as open source (GPL2). The firmware is a generic puls sender/ | ||
+ | |||
+ | Instructions on how to install the firmware can be found [[installculfirmware|here]]. | ||
- | The CUL 433 device requires firmware (for the on board ATMega32U4 processor). There is a separate NetHome project for firmware for this device and this is available as open source (GPL2). The firmware is a generic puls sender/ | ||
NetHomeServer interfaces with the CUL transceiver via the [[cultransceiver | CULTransceiver]]-Item and via the CUL device the Nexa and X10-devices can be controlled. | NetHomeServer interfaces with the CUL transceiver via the [[cultransceiver | CULTransceiver]]-Item and via the CUL device the Nexa and X10-devices can be controlled. | ||
Line 13: | Line 19: | ||
NetHomeServer-actions. | NetHomeServer-actions. | ||
===== Where to buy ===== | ===== Where to buy ===== | ||
+ | [[http:// | ||
cul.txt · Last modified: 2018/11/03 02:59 by 127.0.0.1