This module is a part of the NetHomeServer. The AudioProtocolTransmitter receives protocol message events and transmits them as pulses on the specified audio channel. The following protocols are currently supported:

• Nexa_Message
• NexaL_Message
• Deltronic_Message
• X10_Message
• Pronto_Message

Some kind of transmitting hardware is needed to convert the audio signals from the speaker output into an RF or IR signal.

• SourceNumber [get] [set] The number of the audio channel to use as output
• Source 0 [get] Name of audio channel 0
• Source 1 [get] Name of audio channel 1
• Source 2 [get] Name of audio channel 2
• Source 3 [get] Name of audio channel 3
• Source 4 [get] Name of audio channel 4
• Source 5 [get] Name of audio channel 5
• FlankSwing [get] [set] The level of the output signal [1 - 127].

• PlayTestBeep Will transmitt a short square wave output of 2KHz for 0.8 seconds. This is used for test purposes.

NetHomeServer