This module is a part of the NetHomeServer. The X10Port manages the connection to the CM12-interface module via a serial port. The CM12-interface module can send and receive X10 commands over the mains wires. Recieved X10 messages are transmitted as Events over the internal NetHomeServer event bus. The X10 protocol uses separate address and function messages and the actual devices knows who is currently addressed. The X10Port hides this for outgoing messages.

• ComPort [get] [set] Serial port where the CM12 is connected. For example COM1 on windows or /dev/ttyUSB0 on Linux
• State [get] Current connection state to the hardware device, “Connected” or “Not Connected”
• ReceivedMessages [get] Number of received messages
• SentMessages [get] Number of sent messages

• reconnect Tries to reconnect if the connection to the interface failed at startup.

• Emits X10Address(HouseCode, DeviceCode) This event is emitted when an X10 address command is received from the CM12.
• Emits X10Function(X10Type, HouseCode, DeviceCode) This event is emitted when an X10 function command is received from the CM12. The command is directed to the device addressed by the last X10Address command.

Note: All received events heed the “Target” attribute if it is specified. The received events can be considered an internal interface, please use the corresponding X10Lamp or X10Scene to control devices.

• Receives X10AllLightsOff(HouseCode) Turns off all X10 devices regarded as lamps with the specified HouseCode
• Receives X10AllLightsOn(HouseCode) Turns on all X10 devices regarded as lamps with the specified HouseCode
• Receives X10AllUnitsOff(HouseCode) Turns off all X10 devices with the specified HouseCode
• Receives X10PresetDim1(HouseCode) Switches all X10 devices with the specified HouseCode to preset Dim state 1
• Receives X10PresetDim2(HouseCode) Switches all X10 devices with the specified HouseCode to preset Dim state 2
• Receives X10SwitchUnitOff(HouseCode, DeviceCode) Turns off the specified X10 device
• Receives X10SwitchUnitOn(HouseCode, DeviceCode) Turns on the specified X10 device
• Receives X10BrightUnit(HouseCode, DeviceCode) Brights the specified X10 device
• Receives X10DimUnit(HouseCode, DeviceCode) Dims the specified X10 device

NetHomeServer, X10Lamp, X10